Pulsafeeder Chem-Tech Series XP TIMER EN Manual de usuario

REV. A PN J63143 - 1 - XP Peristaltic Pump Installation, Operation and Maintenance Manual 7 Day Electroni

REV. A PN J63143 - 10 - 12. Skip cycle button; ‘ may be used when you want to skip all program sequences pro

REV. A PN J63143 - 11 - 5.2. General DANGER: DO NOT ATTEMPT TO FEED CHEMICALS WITHOUT FIRST CONSULTING YOUR

REV. A PN J63143 - 12 - 6.1. Tubing Assembly Removal Always wear protective clothing and safety glasses when

REV. A PN J63143 - 13 - 5) Remove pump head tube assembly by removing both connector fittings and pulling tub

REV. A PN J63143 - 14 - Figure 9a: Rotor Alignment at Start of Tube Installation 3) Insert one connector en

REV. A PN J63143 - 15 - Figure 9c: Finishing the New Tube Installation 6) Using the mode selector switch

REV. A PN J63143 - 16 - 7. Policies and Procedures 7.1. Manufacturers Product Warranty PULSAFEEDER warrants

REV. A PN J63143 - 17 - All material must be returned freight prepaid. All merchandise must be properly packa

REV. A PN J63143 - 18 - Appendix I. Pump Assembly and Wiring Diagram

REV. A PN J63143 - 19 - Maintenance Record Date Maintenance Performed

REV. A PN J63143 - 2 - TABLE OF CONTENTS 1. Introduction...

REV. A PN J63143 - 20 - EC Declaration of Conformity We, Pulsafeeder Inc., declare under sole responsibilit

REV. A PN J63143 - 3 - 1. Introduction Thank you for your purchase of the Chem-Tech Series XP peristaltic pum

REV. A PN J63143 - 4 - • WARNING: All pumps are factory tested with water. Remove tubing and thoroughly dry i

REV. A PN J63143 - 5 - Figure 2: Injector Placement Vertical Mount Horizontal Figure 1: Pump Dimensions 4.

REV. A PN J63143 - 6 - 4) Apply Pipe tape to the injection fitting threads and install into piping system. Do

REV. A PN J63143 - 7 - Figure 6 As previously mentioned the mode selector switch has three

REV. A PN J63143 - 8 - PUMP TIMER PROGRAMMING INSTRUCTIONS 1. Read all instructions first. 2. When programm

REV. A PN J63143 - 9 - 3. Slide the programming selector switch to center, ‘RUN’ position to check time