Pulsafeeder Pulsar Series HypoPump Manual de usuario

USER NOTE: This serves as additional information for Pulsafeeder PULSAR® and PULSAR Shadow® metering pumps

6 7. Description and Operation 7.1 Principle of Operation Reciprocating metering pumps are used with a wide variety of chemicals, such as sodium hy

7 8. Maintenance NOTE: This section only refers to models purchased and installed prior to [date] and is for reference only. Replacement parts are n

8 8.2 Flapper Valve Replacement 1. Remove automatic valve assembly completely from pump, as per the instructions in the previous section. 2. Remove

9 9. Troubleshooting Guide Symptom Probable Cause Possible Solution Pump does not prime (product side) Purge relay not operational Verify power is

10 10. Wiring Diagrams Figure 7 It is recommended that the AVA be powered from a Ground Fault Circuit Interrupter (GFCI) protected electrical circui

11 PULSAR® HYPOPUMP® SODIUM HYPOCHOLORITE METERING PUMP Bulletin #: PS-IOM-HYP-0203-I A unit of IDE

ii FACTORY SERVICE POLICY If you are experiencing a problem with your Pulsafeeder pump, first review the IOM, and consult the troubleshooting guide.

iii Table of Contents 1. CONVENTIONS ...

iv 1. Conventions For the remainder of this bulletin, the following Conventions are in effect. A WARNING DEFINES A CONDITION THAT COULD CAUSE DAMA

1 2. General Safety The Automatic Valve Assembly (AVA) was designed as a gas handling/priming aid for operation solely with Pulsafeeder PULSAR® and

2 3. Equipment Inspection When you receive your order, check all equipment for:  Completeness against the shipping document / purchase order  Evi

3 5. Overall System Diagram Figure 1PULSAR® HypoPump® System Diagram

4 6. Installation 6.1 Location Review the Safety section prior to installing the pump with AVA. It contains information required to properly insta

5 AVOID LOCATIONS WHERE THE AVA WOULD BE SUBJECTED TO EXTREME COLD OR HEAT OR DIRECT SUNLIGHT. FAILURE TO OBSERVE THIS WARNING COULD DAMAGE THE AVA